Connecting the battery cabinet to the wires
Select the electric wire size of which the rated current is equal to or over that of the battery cabinet input/output wiring. Use wires that have a dielectric strength. . A. In order to maintain safety during installation and maintenance to the battery cabinet, certified service personnel familiar with the operation of this equipment must be present. The following. . IMPORTANT: Before installing, connecting to supply or operating your VertivTM Liebert® ITA2 Battery Cabinet, please review the Safety and Regulatory Statements sheet. For installations with two hole cable lugs only, temporarily remove the protection cover. NOTE: The protection cover must be reinstalled when the DC- cable has been connected. Place batteries on shelf (Figure 1). [PDF Version]FAQS about Connecting the battery cabinet to the wires
How do I connect a battery cabinet to an ups?
Connect the DC+ and DC- cables to the DC+ and DC- terminals. Connect the power cables in the UPS. If more battery cabinets are part of the solution, connect all battery cabinets to the UPS according to the diagram below.
How to install a battery cabinet in the battery solution?
1. Perform the following steps on all battery cabinets in the battery solution. a. Remove the cover in front of the start-up button and push the start-up button. • The PSU2 LED and the POWER LED will turn on. • The ABNORMAL and ALARM LEDs should remain off. b. Reinstall the cover in front of the start-up button.
How do I connect 0w76928 to a battery cabinet?
1. Route signal cable 0W76928 from CAN 2 port of battery cabinet 1 to the CAN 1 port of battery cabinet 2. Repeat for the remaining battery cabinets. Do not connect the CAN cables, Schneider Electric service will complete the connections during start-up.
How to connect a UPS battery to a host?
F. Before connecting the battery cables from the battery cabinet to the host, measure the battery voltage with a multimeter, which should be 103.36V, and check if the positive and negative leads are correctly connected. If there is a battery box, connect the batteries in series and link them to the host as required. 2. UPS Battery Wiring Example A.